The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?A．Assign the switch a higher MAC address tha

题目

The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?

A．Assign the switch a higher MAC address than the other switches in the network have

B．Establish a direct link from the switch to all other switches in the network

C．Configure the switch full-duplex operation and configure the other switches for half-duplex operation

D．Configure the switch so that it has lower priority than other switches in the network

E．None of the above

更多“The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?A．Assign the switch a higher MAC address tha”相关问题

第1题

What are the switch and bridge port characteristics of a layer two spanning－tree network that is fully converged?()A. All switch and bridge ports are in the forwarding state.B. All switch and bridge ports are in the stand-by state.C. All switch and bridge ports are assigned as either root or designated ports.D. All switch and bridge ports are in either the forwarding or blocking state.E. All switch and bridge are either blocking or looping.

点击查看答案
第2题

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning－tree instance of vlan 1?()A. the switch with the lowest MAC addressB. the switch with the higest MAC addressC. the switch witch the higest IP addressD. the switch with the lowest IP address

点击查看答案
第3题

The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network?（）A. Lower the bridge priority number.B. Change the MAC address of the switch.C. Increase the VTP revision number for the domain.D. Lower the root path cost on the switch ports.E. Assign the switch an IP address with the lowest value.

点击查看答案
第4题

Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?()A.It has more than one interface that is connected to the root network segment.B.It is running RSTP while the elected root bridge is running 802.1d spanning tree.C.It has a higher MAC address than the elected root bridge.D.It has a higher bridge ID than the elected root bridge.

点击查看答案
第5题

Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0／10 is not the root port for VLAN 2?()A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.C.This switch interface has a higher path cost to the root bridge than another in the topology.D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

点击查看答案
第6题

Which three statements accurately describe layer 2 Ethernet switches?()A.Microsegmentation decreases the number of collisions on the network.B.if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.C.Spanning Tree Protocol allows switches to automatically share vlan information.D.In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.E.Establishing vlans increases the number of broadcast domains.F.Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

点击查看答案
第7题

A network administrator needs to force a high-performance switch that is located in the MDF to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge（）。A.Establish a direct link from the switch to all other switches in the network.B.Assign the switch a higher MAC address than the other switches in the network have.C.Configure the switch so that it has a lower priority than other switches in the network.D.Configure the switch for full-duplex operation and configure the other switches for half-duplex operation.E.Connect the switch directly to the MDF router, which will force the switch to assume the role of root bridge.

点击查看答案

思科认证

The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?A．Assign the switch a higher MAC address tha

题目

更多“The Ezonexam network administrator needs to a switch named VE1 to become the root bridge for a redundant path switched network. What can be done to ensure that VE1 will always assume the role as the root bridge?A．Assign the switch a higher MAC address tha”相关问题

第1题

第2题

第3题

第4题

第5题

第6题

第7题

相关内容