请回答HSRP的转换时间是多长时间

第1题

请指出:以下选项中的哪些字段是HSRP协议报文的受部字段?()A.StateB.ActionC.HellotimeD.PriorityE.Group

点击查看答案

第2题

在HSRP中，使用默认计时器，备用路由器经过多长时间才能检测到活跃路由器的失效情况？（）A、3秒B、9秒C、10秒D、15秒

点击查看答案

第3题

HSRP has been configured between two Company devices.  Which of the following describe  reasons for deploying HSRP？ （）A、 HSRP provides redundancy and fault toleranceB、 HSRP allows one router to automatically assume the function of the second router if the second  router failsC、 HSRP allows one router to automatically assume the function of the second router if the second  router startsD、 HSRP provides redundancy and load balancing

点击查看答案

第4题

Hot Standby Router Protocol (HSRP) is able to provide network redundancy for IP networks. Concerning HSRP load sharing, which two descriptions make sense?（）A、It is achieved by using more than one HSRP group.B、It is done in regards to either round robin or weight basis.C、It is used to offload the active router in a certain HSRP group.D、The return traffic is influenced by HSRP load sharing configuration.E、Single group HSRP is used to achieve more efficient link utilization.

点击查看答案

第5题

Routers R1 and R2 use HSRP so that one router will back up the other should there be a failure.   Which two statements are true about the Hot Standby Router Protocol （HSRP）？ （）A、 Load sharing with HSRP is achieved by creating multiple subinterfaces on the HSRP routers.  B、 Routers configured for HSRP can belong to multiple groups and multiple VLANs.C、 Load sharing with HSRP is achieved by creating HSRP groups on the HSRP routers.D、 All routers configured for HSRP load balancing must be configured with the same priority.  E、 Routers configured for HSRP must belong to only one group per HSRP interface.

点击查看答案

第6题

Which three statements best describe HSRP configuration on Cisco Nexus switches？（）A、 In a vPC topology， the primary HSRP router will respond to ARP requests， but both HSRP routers will forward data traffic. No additional configuration is required.B、 In a vPC topology， the primary HSRP router will respond to ARP requests， but both HSRP routers will forward data traffic if the peer-gateway feature is enabled.C、 You can configure two overlapping HSRP groups to load share traffic from the connected hosts while providing the default router redundancy.D、 You can use the show standby command to verify HSRP operation and configuration.E、 If you remove the feature hsrp command， all relevant HSRP configuration information isalso removed.

点击查看答案

第7题

释迦牟尼佛的教法，为何又叫普贤密意圣教？它会住世多长时间？请具体说明各个时期的特征。

点击查看答案